Blew a tire on the left side of my gooseneck LQ. Two wires hanging, one green, one yellow. According to the 7 pin schematic...the yellow should be for the left signal and green for the right...um...signals work, running lights do not and an auxillary compartment light above the tire wheelwell has to be replaced . Emergency 4 ways also work. Which should go to the running lights???
Posted 2017-09-19 8:11 PM (#170656 - in reply to #170651) Subject: RE: Merhow wiring problem...HELP!
Extreme Veteran
Posts: 448 Location: Los Angeles, Ca.
Look for a junction box in the vicinity of where the wires were pulled loose. Colors of wires not necessarily what is on the schematic. Use a 12v test light to determine which wire is for the running lights.....turn on headlights and see which wire gets power
Posted 2017-09-20 2:41 AM (#170666 - in reply to #170651) Subject: RE: Merhow wiring problem...HELP!
Expert
Posts: 3853 Location: Vermont
Checking with a continuity tester is the easiest...but you may check to see if your trailer might have been wired RV standard... Black wire 12 volt power Tail and running lights are green wire, Yellow wire is Reverse lights Brown wire is Right turn and stop Red wire is Left turn and stop Blue wire is brake controller output White wire is ground
Posted 2017-09-21 8:21 AM (#170678 - in reply to #170651) Subject: RE: Merhow wiring problem...HELP!
Expert
Posts: 2955 Location: North Carolina
Raffonel ... Thanks for closing the question. Too many folks ask for help and then disappear. We never get to know if our advice/guesses were correct for the next person.
Merhow wiring problem...HELP!
FIXED!! Truck fuses blew when wiring got shredded!