Just bought a new trailer, have made a few posts in regards to it this morning.  One of the things I would like to improve is the look of the door going from the LQ to the MT, it is bare alluminum.  I am very paticular about things and most of the time my skills can't live up to my standards.  Attached is a picture of the door, any ideas about a simple DIY solution that may make the door look nicer and fit the LQ better?  I am actually suprised it isn't finished as the rest of the LQ is professionally done and looks really nice but the door was just left as is.

Mike

Many will be covered with a vinyl material to match the walls in the trailer. They will have the vinyl glued to a thin piece of paneling, and then glued to the door with screws in the corners covered with buttons. By putting the vinyl on the paneling it will allow you to wrap over the edges creating a more finished look.