Posted 2013-06-09 6:17 PM (#152572) Subject: no power at + pin of trailer receptacle
New User
Posts: 3
Location: East Centrsl MN
I have no power at the + pin of the trailer receptacle on my 06 Ram. So the interior lights on my trailer do not work. The trailer plug is fine,as everything works when I plug the trailer into itself ( I mounted a battery box & receptacle to be able to use the lights when the truck is not hooked up) I think this happened a couple years ago & it was a fuse, this time all the fuses appear to be good.
Posted 2013-06-09 6:54 PM (#152574 - in reply to #152572) Subject: RE: no power at + pin of trailer receptacle
Veteran
Posts: 178
Location: Richmond, Ky
you really need an ohm-meter to correctly check fuses, they really need to be removed from the circuit to be checked. If you don't have a ohm-meter a visual inspection might work, but sometimes you could miss a blown fuse.
good luck
Posted 2013-06-09 6:57 PM (#152575 - in reply to #152572) Subject: RE: no power at + pin of trailer receptacle
Veteran
Posts: 109
Location: Florida
Did you have the truck key to "run" when trying the inside trailer lights? My Chevy doesn't need the key on but my Ford dose, not sure how dodge is setup.
Posted 2013-06-09 7:25 PM (#152576 - in reply to #152572) Subject: RE: no power at + pin of trailer receptacle
New User
Posts: 3
Location: East Centrsl MN
visual inspection of the fuse looked ok, swapped it out with a new one & same results. Did not check either fuse with an ohm meter. Does not make a difference if the ignition is on or off.