Posted 2009-03-20 1:03 PM (#101822) Subject: Getting parts for LQ conversion from salvage campers?
Member
Posts: 39
Location: Michigan
I am wondering if it would be more cost effective to try to find a salvage camper or other inexpensive used camper to do our LQ? I am not finding any resources close to us to get all the things we need, so that would help in that department as well. I figured we could use the water heater and pump, the dinette and or couch, fridge, stove microwave, etc. out of a camper.
Has anyone ever used parts from a camper to do you LQ?
Do you think it would be more/less expensive or about the same as buying everything individually?
Scrapping the left over shell isnt an issue for us, we have the resources to take care of that.
And where is a good place to find something like that? I am not seeing much on Ebay, except for some 1970's models and we want decent stuff.
Posted 2009-03-20 1:50 PM (#101825 - in reply to #101822) Subject: RE: Getting parts for LQ conversion from salvage campers?
Extreme Veteran
Posts: 406
Location: Minneapolis, MN
I see your from Michigan?
There are numerous places not that distant from you. Bontrager's being one of them. And Elkhart Indiana just across the border....surplus and take-outs.
Posted 2009-03-20 4:29 PM (#101833 - in reply to #101822) Subject: RE: Getting parts for LQ conversion from salvage campers?
Expert
Posts: 5870
Location: western PA
In my area, used truck campers are sold very inexpensively, with the larger units selling for less than the 8'-9' models. They have many components that can be adapted to a DIY LQ. Entire kitchens; fridge, sink, faucets, gas cook tops, ovens and a microwave are commonly installed.
A complete electrical system with converter/charger, shore cord, lighting fixtures, outlets, breaker/fuse box, etc. The bath rooms have flushing toilets and often, built in above the floor holding tanks. Some have showers and sinks. Most have dinettes with a table and cushions.
They have complete water systems, water pump, water heater, and potable water tank. Most have separate gray and black water tanks. A complete propane gas system is included, regulator, fittings, some have furnaces and most have hot water heaters. The approved exterior access panels and vents are installed for each gas appliance.
Individually these parts would cost a couple of thousand dollars new. The used market values on the older aluminum skinned units are very low, usually only few hundred dollars. The new fiberglass ones are pricy new and used, unless you can find a damaged unit.
Posted 2009-03-22 6:24 AM (#101894 - in reply to #101822) Subject: RE: Getting parts for LQ conversion from salvage campers?
Elite Veteran
Posts: 662
Location: Vanzant, Missouri
Here is a link for used camper parts. I have used this site before for parts. I had an older 5th wheel(78) that I got replacement parts for. Might help you.. http://rvbasics.com/techtips/oldparts.html