Do all horse and stock trailers have brakes, or is this a recent thing?
I am going to be looking at an older stock trailer (late 80's) and I don't think they mentioned anything about the brakes. Well I guess I'll find out...
I have a 4x4 diesel F250 with a tekonsha controller, so I'm good on my end, but what do you look at on the trailer side as far as good, safe equipment?
Posted 2005-10-26 8:59 PM (#32382 - in reply to #32379) Subject: RE: trailer brake question
Expert
Posts: 2955
Location: North Carolina
Welcome to the forum... Electric trailer brakes are not even good at their best. I would want brakes on both axles. Forget just one axle brake systems.
Posted 2005-10-26 9:38 PM (#32386 - in reply to #32382) Subject: RE: trailer brake question
Expert
Posts: 1416
Location: sc
Originally written by hosspuller on 2005-10-26 9:59 PM
Welcome to the forum... Electric trailer brakes are not even good at their best. I would want brakes on both axles. Forget just one axle brake systems.
i may not go that far, i think they work pretty well with some of these newer model brake controllers. but i do agree with brakes on both axles, if the trailer is heavy enough to need two axles, it needs brakes on both.
Posted 2005-10-27 10:26 AM (#32404 - in reply to #32379) Subject: RE: trailer brake question
Member
Posts: 5
Location: Sacramento, CA
Brakes on both axles seems good advice. Is it fairly straightforward to install brakes on an axle that doesnt have them? What would the cost be, roughly?
Posted 2005-10-27 11:40 AM (#32408 - in reply to #32404) Subject: RE: trailer brake question
Expert
Posts: 2689
Originally written by mannabell on 2005-10-27 10:26 AM
Brakes on both axles seems good advice. Is it fairly straightforward to install brakes on an axle that doesnt have them? What would the cost be, roughly?
Yes, simple, easy, DIY'able.
Cost could go two ways, if there are already flanges for the backing plates on the unbraked axle - or not.
I'm with Hosspuller, straight electric brakes are poor at their best.
Electric over hydraulic is preferable, though that isn't what you asked.
If I was building "from scratch" or doing a major re-furb I'd probably blow the extra bux and put disks on ("disques" ?).
Posted 2005-10-31 6:34 AM (#32518 - in reply to #32486) Subject: RE: trailer brake question
Expert
Posts: 2689
Right, "D_I_S_C", gottit !
That was when I went INTO Hi-tek, by the time I got out it was D_I_S_K and I remember the discussions (diskussions ?) over which it should be - for data.
Anyway, they're still discs in the spine - or the Latin equiv.