so been casually looking at upgrading to an LQ trailer
one thing i've been seeing on occasion is a wall between the bunk & everything else. how the heck do you get the old mattress out and a new mattress in? or are you stuck with the matress from factory?
Posted 2018-02-16 5:01 AM (#171281 - in reply to #171279) Subject: RE: Mattress replacment
Elite Veteran
Posts: 656 Location: Rayne, LA
? -Like was said you should be able to fold in half or kind of roll up the old one. If it is not good with a little imagination you can remove the old one. Our trailer is like you described with a sliding door closing off the bedroom area and we replaced ours with one like this-- -https://www.amazon.com/gp/product/B00NX8G4LK/ref=oh_aui_detailpage_o03_s00?ie=UTF8&psc=1
Posted 2018-02-16 8:59 AM (#171283 - in reply to #171279) Subject: RE: Mattress replacment
Veteran
Posts: 113 Location: Wi
Easiest way is to take two pieces of rope with a loop thru the end. One person at each end (head/foot), put the rope under the mattress and feed the end of the rope thru the loop. Now roll the mattress like a burrito and tighten the rope as you go. When you have it rolled as tight as you can tie off the rope. Use the rope as a handle and use it to "walk" it out of the trailer.
If you buy a mattress for a trailer, they typically are shrink wrapped into a burrito shape. Put in place, cut the shrink wrap and stand back.
Posted 2019-05-14 1:51 PM (#172381 - in reply to #171279) Subject: RE: Mattress replacment
Extreme Veteran
Posts: 402 Location: Valentine, NE
If you replace a LQ mattress, be aware that a lot of LQ noises are very low clearance, and the factory mattress is a "low profile". IMO that is why most of them suck-as they are thin for more clearance. But when you put a "normal" mattress in a LQ, expect to lose 2-6" of head clearance.
Mattress replacment
