Installation of WERM flooring aftermarket
nolefan
Reg. Jun 2006
Posted 2006-10-26 5:57 PM (#50687)
Subject: Installation of WERM flooring aftermarket


Regular


Posts: 57
2525
Location: FL

Hello

Does anyone no of a reputable service center that installs WERM flooring aftermarket in either Alabama, Florida or Georgia?

Thanks

 

share Top of the page Bottom of the page
AbbyB
Reg. Nov 2003
Posted 2006-10-29 8:10 AM (#50794 - in reply to #50687)
Subject: RE: Installation of WERM flooring aftermarket


Veteran


Posts: 247
10010025
Location: NW

I would go to teir webstie & see who they have listed - if no one in the area you are looking for, contact them....I know they have crews that go out on location to do horse stalls in the barn & can sometimes do a trailer when on site.

oops, forgot to add the website! 

http://www.wermflooring.com/



Edited by AbbyB 2006-10-29 8:13 AM
share Top of the page Bottom of the page
goethetrail
Reg. Oct 2006
Posted 2006-10-29 8:22 AM (#50795 - in reply to #50794)
Subject: RE: Installation of WERM flooring aftermarket


Member


Posts: 21

Location: Levy County, Florida
I emailed them and asked if there were FL distributors...answer was no.
share Top of the page Bottom of the page
arlene21
Reg. Aug 2006
Posted 2006-10-30 8:17 PM (#50876 - in reply to #50687)
Subject: RE: Installation of WERM flooring aftermarket


Veteran


Posts: 192
100252525
Location: Kentucky

Here is an answer to a thread about WERM flooring installation. I called and was going to have it done but purchased a different trailer instead. Maybe they can help you.

Hi - WERM flooring can be put in ANY older trailer - they usually clean and prep it before "pouring" the WERM - we had our 8 year old 4-Star done, including the rear tack and the mid tack - it was a 3 horse slant/mangers except in the first stall - and at the Dealer in Oklahoma City, OK - they installed it for $525.00 - in 2004.....the owner is Kris Parmer and he has other dealerships in different parts of the country - give him a call....1-800-350-7564....BUT now we have a Sundowner trailer that has the "planked-type" aluminum floor - and it is going to cost TWICE as much to do it - because it has to be "skim" - coated first and then after that sets....another coat! We live in Michigan and we finally have a dealer here on the western side of the state.....WE LOVED the WERM floor - I'm on the little, weak side and I sure hated dragging those mats in and out to pressure wash the floor after each use!

share Top of the page Bottom of the page
bjhouten
Reg. Nov 2004
Posted 2006-11-01 10:55 AM (#50944 - in reply to #50687)
Subject: RE: Installation of WERM flooring aftermarket



Extreme Veteran


Posts: 560
5002525
Location: Mena, AR
Is there a WERM floor installer closer to Dallas, TX than the one in OK City. I contacted WERM, and they recommended the OK City dealer. They didn't response to my request for a one closer to Dallas.

-Betty
share Top of the page Bottom of the page
arlene21
Reg. Aug 2006
Posted 2006-11-01 10:59 AM (#50945 - in reply to #50687)
Subject: RE: Installation of WERM flooring aftermarket


Veteran


Posts: 192
100252525
Location: Kentucky
When I called, they gave me the name of someone only 2 hours away in Illinois. I thought maybe they had people in every state.
share Top of the page Bottom of the page
bechack
Reg. Mar 2006
Posted 2006-11-01 3:05 PM (#50953 - in reply to #50687)
Subject: WERM vs Rhino


Veteran


Posts: 134
10025
Location: Coarsegold, CA
So has anyone done a side by side comparison on these two flooring treatment options?

share Top of the page Bottom of the page
Copper1272
Reg. Nov 2006
Posted 2006-11-02 1:18 PM (#51001 - in reply to #50687)
Subject: RE: Installation of WERM flooring aftermarket



Regular


Posts: 51
2525
Location: Labelle, FL
If you call their 800# they have someone in or near Tampa I think.
share Top of the page Bottom of the page