|
|
Member
Posts: 8
Location: Dallas, GA | Can someone please tell me how to change the bulbs on these lights? I think you probably have to remove the ring from around the light to access the bulb but am afraid I am going to break something and can't get to it. I'm going to try to attach a picture so you can see it. |
|
| |
|
Member
Posts: 8
Location: Dallas, GA | okay, can't seem to upload a picture since it's too big. But, it's the flush mount kind with the gold looking metal (plastic) ring around it and flush with the wooden surface. Any ideas? Thanks! |
|
| |
|
Veteran
Posts: 133
 
Location: NC | ring should either pop off or unscrew fairly easily. |
|
| |
|
Veteran
Posts: 124
Location: Calgary, Canada | Try placing a strip of duct tape across the entire light and light ring overlapping the duct tape a few inches across each side of the ring. Grab the overlapped edges of the tape and twist counter clockwise to remove the light ring. The duct tape should give you the extra "grip" required to remove these twist type lights. Regards, 3CW |
|
| |
|
Veteran
Posts: 211
Location: El Paso, Texas | I changed all my inside lights to LED, even the refrigerator light. On some of my rings they were really tight and I could not get a grip to get them off. I used an oil filter wrench and they all came on and off with no effort |
|
| |
Need Help with LQ inside light
