|
|
New User
Posts: 3
Location: Dripping Springs, TX | I am adding a weekender to a Sundowner Value Lite (2003. I have removed the sheet metal on all walls ad would like to remove the floor carpet (original)and take a look at the sub-flooring but I CANNOT get the floor to budge. I suppose it is glued down with super-human-no-removal glue so I am wondering if there is anything I am missing other than just forcing this original sub-floor loose.If I am unable to get it removed, are there any obvious problems with installin a new sub-floor on top of the carpet and then putting my desired flooring down?Help! |
|
|
|
Elite Veteran
Posts: 801
Location: Tenn/Ala. | Look underneath. If I am not mistaken, they wrapped sheets of plywood with carpet, and layed them in the floor. There oftentimes were screws coming up from the bottom into the wood. And no- you need to make sure and get it out before you install anything else on it. It is over 10 years old already, and wasn't designed to be a LQ floor. |
|
|
|
Expert
Posts: 5870
Location: western PA | Putting a new floor over carpeting will invite an area that can absorb and hold moisture. This would be a good incubator for mold problems. If the carpeting isn't installed onto plywood and instead it's glued to the structure, a heat gun can soften the glue enough to rip the carpeting free. As Richard said, look for screws first. |
|
|
|
New User
Posts: 1
Location: 3326 Centennial Farm Road Nemaha, IA 50567 | I am not getting your exact problem related to flooring so can you tell in simple words so that I can also help you out.see here |
|
|
|
New User
Posts: 3
Location: Dripping Springs, TX | Problem...I can't get the sub-floor up to replace it. I want to remove the original carpeting and replace it with LQ quality flooring. I originally just wanted to remove the carpeting, but can't figure out how to remove it. Suggestions? |
|
|
|
Regular
Posts: 97
Location: mancelona michigan | are you sure that what you are calling "sub flooring" isnt actually the deck of the trailer? what is it made of? |
|
|
|
New User
Posts: 3
Location: Dripping Springs, TX | Good point...I be looking into this immediately. |
|
|