|
|
Veteran
Posts: 147
 
Location: Cornfield in Iowa | |
|
| |
|
Veteran
Posts: 147
Location: Cornfield in Iowa |  Just wondering, I'm kind of a worry wart. My truck is a 2001 so that ball is 13 years old....do they wear out? |
|
| |
|
Expert
Posts: 2957
 
Location: North Carolina | Anything can break, but wearing out a ball is unlikely. The most important parts are the neck and the diameter of the ball. Just put a dab of grease on the ball before hitching and you'll be fine. |
|
| |
|
Extreme Veteran
Posts: 379
Location: Missouri | I would only replace it if the ball was subjected to an impact. |
|
| |
|
Extreme Veteran
Posts: 350
Location: Penrose, Colorado | I had a friend last year that went over a big bump and his trailer came off of the ball, it was so worn on the front side that it was almost flat so we changed that out and his hitch on the trailer was almost as bad, so we put a new one on it also, both were 10-15 years old and had been used quite a lot. |
|
| |
|
Expert
Posts: 2957
Location: North Carolina | Originally written by kooner on 2014-07-24 12:19 PM
I had a friend last year that went over a big bump and his trailer came off of the ball, it was so worn on the front side that it was almost flat so we changed that out and his hitch on the trailer was almost as bad, so we put a new one on it also, both were 10-15 years old and had been used quite a lot. If you have a B+W turn-over ball, you could turn the ball 90° every time you flip the ball. That would equalize wear and prevent kooner friend's situation. |
|
| |
|
Veteran
Posts: 147
Location: Cornfield in Iowa | Originally written by hosspuller on 2014-07-24 6:52 PM Originally written by kooner on 2014-07-24 12:19 PM
I had a friend last year that went over a big bump and his trailer came off of the ball, it was so worn on the front side that it was almost flat so we changed that out and his hitch on the trailer was almost as bad, so we put a new one on it also, both were 10-15 years old and had been used quite a lot. If you have a B+W turn-over ball, you could turn the ball 90° every time you flip the ball. That would equalize wear and prevent kooner friend's situation. |
|
| |
|
Regular
Posts: 73
| I wouldn't put grease on it though. All the sand and dirt will accumulate on your ball and the cupler, then it would be a constant grinding and would wear the ball out and the hitch twice as fast. Also not to mention that the ball and hitch are part of the ground system, with grease you loose that. |
|
| |
|
Extreme Veteran
Posts: 350
Location: Penrose, Colorado | the hitch that I was referring to was on a bumper pull and turning your hitch ball for a goosneck once in a while is a good idea but remember the coupler on the trailer is also suspect but it can also be rotated. |
|
| |
Should you replace your hitch ball periodically?
