Sundowner Running Board
SillyFilly55
Reg. Jun 2005
Posted 2011-10-12 8:36 PM (#138270)
Subject: Sundowner Running Board


Member


Posts: 8

Location: Mississippi

I had a blow out recently on my bp trailer that ripped the fender off.  I ordered all new parts, but didn't think to order the 15 inches of running board that acts as a brace on the rear of the fender.   I have since been searching, but not having much luck trying to locate a one.  

Any advice? 

share Top of the page Bottom of the page
hosspuller
Reg. Oct 2003
Posted 2011-10-13 10:00 AM (#138286 - in reply to #138270)
Subject: RE: Sundowner Running Board


Expert


Posts: 2953
20005001001001001002525
Location: North Carolina

Call Sundowner customer service. Measure the trailer for the missing piece.  Measure from the outside edge of the fender to the end point  (the diagonal) Ask for running board of that length.  You'll have to cut the piece for the angle needed and weld / rivet on.

How do I know this ??

share Top of the page Bottom of the page
SillyFilly55
Reg. Jun 2005
Posted 2011-10-13 10:19 AM (#138289 - in reply to #138286)
Subject: RE: Sundowner Running Board


Member


Posts: 8

Location: Mississippi		LOL!! Thank you!
share Top of the page Bottom of the page
RTSmith
Reg. Nov 2003
Posted 2011-10-13 11:32 AM (#138293 - in reply to #138270)
Subject: RE: Sundowner Running Board


Elite Veteran


Posts: 798
500100100252525
Location: Tenn/Ala.		As HP said, Sundowner's Parts department will need to get involved as it is a proprietory (sp?) extrusion.

But if you'll draw out the piece you need with dimensions and details, they can cut it to fit for you before shipping.
share Top of the page Bottom of the page