Vent over stove
mingiz
Reg. Jul 2004
Posted 2011-04-05 4:21 PM (#132643)
Subject: Vent over stove



Elite Veteran


Posts: 662
5001002525
Location: Vanzant, Missouri		My exhaust vent is dropping down. It looks like a cheap piece of panel board holding it up.It has a small frame down the side from what I can see. Can i just put a few screws in it or should I go and pullout the micro wave and rebrace everything. The trailer hasn't moved since Nov. and it seems it's falling apart just sitting...
share Top of the page Bottom of the page
gard
Reg. Aug 2007
Posted 2011-04-05 5:14 PM (#132644 - in reply to #132643)
Subject: RE: Vent over stove


Expert


Posts: 5870
50005001001001002525
Location: western PA		I would pull the microwave, determine how the vent is affixed, and if necessary, through bolt it to the bottom shelf/cabinet. A temporary repair just means it will fail again in the future.
share Top of the page Bottom of the page
mingiz
Reg. Jul 2004
Posted 2011-04-06 5:13 PM (#132686 - in reply to #132643)
Subject: RE: Vent over stove



Elite Veteran


Posts: 662
5001002525
Location: Vanzant, Missouri

Thanks Gard..For som reason I knew you were going to say that. Guess i have a project to do very soon.

share Top of the page Bottom of the page