Posted 2006-10-29 8:10 AM (#50794 - in reply to #50687) Subject: RE: Installation of WERM flooring aftermarket
Veteran
Posts: 247
Location: NW
I would go to teir webstie & see who they have listed - if no one in the area you are looking for, contact them....I know they have crews that go out on location to do horse stalls in the barn & can sometimes do a trailer when on site.
Posted 2006-10-30 8:17 PM (#50876 - in reply to #50687) Subject: RE: Installation of WERM flooring aftermarket
Veteran
Posts: 192
Location: Kentucky
Here is an answer to a thread about WERM flooring installation. I called and was going to have it done but purchased a different trailer instead. Maybe they can help you.
Hi - WERM flooring can be put in ANY older trailer - they usually clean and prep it before "pouring" the WERM - we had our 8 year old 4-Star done, including the rear tack and the mid tack - it was a 3 horse slant/mangers except in the first stall - and at the Dealer in Oklahoma City, OK - they installed it for $525.00 - in 2004.....the owner is Kris Parmer and he has other dealerships in different parts of the country - give him a call....1-800-350-7564....BUT now we have a Sundowner trailer that has the "planked-type" aluminum floor - and it is going to cost TWICE as much to do it - because it has to be "skim" - coated first and then after that sets....another coat! We live in Michigan and we finally have a dealer here on the western side of the state.....WE LOVED the WERM floor - I'm on the little, weak side and I sure hated dragging those mats in and out to pressure wash the floor after each use!
Posted 2006-11-01 10:55 AM (#50944 - in reply to #50687) Subject: RE: Installation of WERM flooring aftermarket
Extreme Veteran
Posts: 560
Location: Mena, AR
Is there a WERM floor installer closer to Dallas, TX than the one in OK City. I contacted WERM, and they recommended the OK City dealer. They didn't response to my request for a one closer to Dallas.