Posted 2009-01-17 3:37 PM (#97670) Subject: Hammer blow hydraulic jack
Regular
Posts: 65 Location: league city texas
Hello, All. I need to pick some brains. I have a 99 Featherlite 3H LQ. It has a hammer blow hydraulic jack. The foot on the jack is getting pretty rusted. I need to replace it. Can I get just that part? And where? I have been searching the internet for a while and no luck. Is there a good parts place online that carries a lot of this kind of stuff? Thanks ya'll!
Posted 2009-01-18 1:01 PM (#97702 - in reply to #97670) Subject: RE: Hammer blow hydraulic jack
Expert
Posts: 1351 Location: Decatur, Texas
Is it surface just rust or does it actually have rust holes in the metal? If it is surface rust use a wire brush and repaint with a good primer and paint.
If I remember right most of the foot pads are the same. So I would check some local trailer shops around you and see if they have any take off jacks that you could get some parts from.
Posted 2009-01-18 1:10 PM (#97704 - in reply to #97670) Subject: RE: Hammer blow hydraulic jack
Expert
Posts: 5870 Location: western PA
There are sources that routinely sell jack assemblies on Ebay. I have only seen complete units. Perhaps a question to the poster, could identify a source of a foot assembly. Have you contacted the manufacturer?
Posted 2009-01-18 2:05 PM (#97712 - in reply to #97704) Subject: RE: Hammer blow hydraulic jack
Regular
Posts: 65 Location: league city texas
I tried to find them online and it says go to hammerblow.com and that site is no longer viable. Tomorrow I am gonna call a couple of trailer places and see if they can point me to them..
Posted 2009-01-18 2:08 PM (#97713 - in reply to #97702) Subject: RE: Hammer blow hydraulic jack
Regular
Posts: 65 Location: league city texas
Its pretty rusted... I have gone looking at some of the shops but all the footpads I have found are too small. I keep finding 4x6" but mine is more like 10x8". I'll find one, just gotta keep looking. My main concern was having to buy another jack.
Hammer blow hydraulic jack
I know several welders, so problem solved!! 