First in any project is the PLAN! Know where your converter, inverter, outlets, and major "appliances" (AC, pump, lights) will be. Then "rough-in" wiring (plumbing, gas?) and leave the wire ends free to attach the ends to source and load later, try to avoid drilling too many holes in the frame. Make sure any metal edges are smooth where wires will contact them (drilled holes) or use rubber bushings. Insulation and furring was next in my plan. Work around your wiring, etc. Plan your furring strips to support the final paneling or plywood (top and bottom) and about every 16" on center. I tried to have furring or wood studs lined up to also support cabinetry later on. Plywood, paneling and wall surface would be next. I chose to install surface mount wiring on the outside of paneling for my 110 volt outlets. This method is easy to add onto later and provides some wire (conduit) protection. The surface mount wiring has shallow outlet boxes, as I thought that standard boxes would stick out too much (even if mounted within the wall space). Lighting is usually 12 volt and you'll only need to RUN a "hot" wire. A ground can be picked up at the destination of your eletrical load by tapping into the frame. You'll have to evaluate each separate appliance load individually as to mounting depth. Hope this helps, and realize these are just my thoughts and opinions... |